This page contains information about the Owner’s Manual for the ER-1 from Korg. Korg ER-1 Electribe R Rhythm Synthesizer () Drum machine: 8 voices mix of analog modeling and PCM samples with sequencer and Midi sync. Listen to. Check out the Korg Electribe ER-1 Frequently Asked Questions (FAQ) own Patterns in a Pattern Set see page 31 in the ER-1 owners Manual.

Author: Dok Tojanris
Country: Maldives
Language: English (Spanish)
Genre: Business
Published (Last): 4 June 2018
Pages: 476
PDF File Size: 8.20 Mb
ePub File Size: 11.19 Mb
ISBN: 368-1-27409-681-2
Downloads: 53545
Price: Free* [*Free Regsitration Required]
Uploader: Dorn

ELECTRIBE-R mkII/Owner’s Manual

Use the dial or the Select keys to move to the position at which you wish to begin recording. LFO a single bipolar modulator, relative frequency range between 0. Song mode Changing the pattern for a specific position 1.

Press the Pattern mode key to enter Ee-1 mode the key will light. Rotate the dial to select the data that you wish to transmit. Slave devices that receive this Start message will synchronize to the Timing Clock messages subsequently received, and will begin playback from the beginning.

Execute the function shown below each step key. If you wish to save the completed pattern, press the Write key. At flectribe time, press- ing the PLAY key will not start playback.

The value of the motion sequence knob will be held at the note timing of that part. Set the EA-1 channel to “01,” and the ER-1 channel to ” Switching patterns When you switch patterns, Program Change and Bank Select messages [Bn, 00, mm] control change 00[Bn, 20, bb] con- trol change 32 mm: If you wish to select both parts 1 and 2, press the key several times to make manal LEDs blink.


Pattern Set is a function that lets you register a favorite pattern to each of the sixteen step keys, and use the step keys to switch patterns.

Korg Electribe ER-1

In step recording, the trigger and pitch are recorded simulta- neously, but it is not possible to make detailed settings for the gate time. Hold down the Shift key and press step key 14 Delete Pat- tern. Then contact your nearest Korg dealer or the store where the equipment was rlectribe. Editing A Song Editing a song You can manyal a new pattern into a song, or delete an existing pattern.

Adjust the decay speed of the filter envelope.

Korg ELECTRIBER ER-1 Owner’s Manual

If you wish to create a pattern in more detail, use Event Edit refer to p. By using the Select key in conjunction with this to switch pat- tern set groups, you can register and select 16 x 4 epectribe of 64 patterns.

Select keys By pressing these keys to turn the Select LEDs on or off, you can use the sixteen step keys below as up to 64 step keys.


Registering a pattern for Pattern Set 1. Use the cursor keys to make the parameter select LEDs indi- cate Protect.

Downloads | ELECTRIBE-R mkII – Owner’s Manual | KORG (USA)

Part Select section 1. Even after Writing the edited data, it is still possible to restore all songs and patterns etc. Pattern Set cannot be used during recording. For example if the gate time is set to 1. Press the Mode key to enter Song mode or Pattern mode. Before you save data, you must turn off the Memory Protect settings in Global mode. Knob values will be connected smoothly, and the sound will change smoothly. When recording, a one-measure count will be sounded before recording begins.

Rotate the dial to select the pattern for which you wish to make Swing settings. Press the Part Select key to select the part that you wish to edit.

Front and rear panel 2. You can modify the phrase pattern for each part by using the sixteen step keys or by realtime input along electrbie the playback.