Dome Camera Installation Manual Weatherproof and Indoor versions www. Contents Introduction. Menu System Manual. Page 4 of 1. THE DENNARD TYPE DOME CAMERA. The Dennard Dome Camera is a precision unit, offering a wide. The Dedicated Micros Camera has a number of features which can be selected by the System. Supervisor when the dome is installed. Any of these can be.
|Published (Last):||9 January 2009|
|PDF File Size:||10.34 Mb|
|ePub File Size:||11.87 Mb|
|Price:||Free* [*Free Regsitration Required]|
Twist once located dennafd secure, then tighten screw heads C to secure the dome enclosure to the mounting disk. Don’t show me this message again. This offers a range of features which are described below.
It’s a community-based project which helps to repair anything. Scan across the table to identify the values for the blue and yellow switches.
Dennard 2060 PTZ Speed Dome Camera 36 x Optical Zoom with Swan Neck (Fully re-furbished)
Finally secure the plastic cover to the metal pins dejnard the bracket flange. Locating the dome on the fennard of a building will give an increased area of surveillance. Twist to locate and lock.
The DM Dome can be controlled by one of three methods. Picture with intermittent control Cause 1. Check the dome address switches are correctly set for the controller being used. Mounting brackets may have been ordered and delivered separately.
There is no prepared cable included, the connector for the camera is included. Use the serial port connection if serial telemetry is required. Register a dennzrd account. Place dome, complete with attached mounting disc, into the pre-cut hole B in the tile from beneath. Snap fit the tile mount bezel E.
Dedicated Mircros Dennard Installation manual |
Unplug this apparatus during lightening storms or when unused for long periods of time. The location of the switches is also shown. Cut or drill a hole in the tile in the required dennarrd using the pattern shown below. Twist once located to secure, then tighten screw heads C to secure the dome enclosure to the mounting disk. Dedicated Micros zooms in with Dennard Video The co-ax and power wires are always connected, the RS wires are only connected when an external protocol converter is fitted or an RS controller is being used.
The installer is responsible for ensuring the fixings used to mount the dome are suitable for the material and will adequately support the weight of the dome.
Check the DVR is set to use the correct telemetry protocol and address settings. Up the Coax Configuration Switch settings The switches are color coded, blue and yellow, and are located inside the dome camera housing. Finally secure the plastic cover to the metal pins on the bracket flange C. Attach safety bond to a suitable secure position in the ceiling void. Attach the mounting ring to the dome using the provided 6 x M3x8 fixings C.
Remove and retain the four screws securing the shield to the head and lift off the shield. Hi, I am completely new to cctv, in fact I am installing a setup at my home, I am not a professional installer or anything like that so please vennard my lack of technical knowledge.
Ceiling installation is made easier by removing an adjacent ceiling tile during installation. Do not show this again. Finally secure the plastic cover to the metal pins on the bracket flange. For this application, Dedicated Micros offer an optional corner bracket, DM to adapt the standard wall bracket. Ceiling Mounting – Weatherproof Dome Attach the mounting disc B to the ceiling in the chosen position and fix 4x M6x16 socket head cap screws supplied into the bushes C as shown below.
This lead should be connected to the boxed P. Page 32 – Dm fixed attitude dome cennard – ‘zo