Avital LX L • 1-Way Remote Start System Keyless Entry and 2 Remote Transmitters Remote Start Vehicle System with two transmitters • Panic and. Buy Avital Avistart Remote Auto Car Start Starter & Keyless Entry System L at Once an Avital Remote Start package is purchased, you can either take it to a mechanic to have the system installed or you can do it yourself. If you decide.

Author: Gardagar Zulkik
Country: Benin
Language: English (Spanish)
Genre: Love
Published (Last): 18 April 2014
Pages: 152
PDF File Size: 19.52 Mb
ePub File Size: 4.20 Mb
ISBN: 602-8-89212-451-2
Downloads: 63876
Price: Free* [*Free Regsitration Required]
Uploader: Tunos

Avital 4103 Installation Manual

Troubleshooting Troubleshooting The starter cranks for six seconds but does not start. Heavy Gauge Relay Interface Heavy gauge relay interface The 4103lxx gauge wires are used to energize high current circuits in the vehicle. Feature descriptions The features of the system are described below with default avittal in bold. Once the remote start is activated, the paneling can be placed back onto the interior of the car and the process is finished.

The Program push-button switch, plugged into the blue port, is used together with a programmed transmitter to change the settings. If you decide to take the DIY route, there are a few simple steps that you can follow to complete the process.

Shutdown diagnostics The unit has the ability to report the cause of the last shutdown of the remote start system. Then, remove the pin red connector. Next, use the trim tool to remove the dash panel trim and the trim above the ignition switch.

  ASTM E413 PDF

How-to-Install-an-AvitalRemote-Start-

It is the default RPM-sensing method for new remote start systems. After the dash panel has been removed, there will be a metal panel that should also be removed. This manual also for: If Feature 2 is programmed to the voltage sense setting, the crank time must be set to the appropriate duration. This feature does not delete the remotes from the security system or reset the Virtual Tach setting.

How to Install an Avital 4103 Remote Start

Use the following learn routine to add transmitters to the avita tem. Troubleshooting The starter cranks for six seconds but does not start. The programmable operating settings of this unit can be changed when- ever necessary through the computer-based Learn Routine. This will program the unlock output to one or two pulses.

Learn Routine will be exited if: You can also narrow down these results by choosing an appropriate category to the left.

Operation is subject to the fol- lowing two conditions: Use it to change the output pulse duration for vehicles that require a longer pulse for the horn to honk. The remote start will be disabled or shut down any time the brake pedal is depressed. The vehicle will start and run only for about 10 seconds. After the remote start module has been installed, test the remote start module in accordance with the Safety Check outlined in this installation guide.

  GULICK URWICK PDF

Do not return the vehicle to the customer until this feature is properly installed! Set the emergency brake.

The default setting is 0. Any attempt to install this product by any. Installing avjtal in a standard transmission vehicle is dangerous and is con- trary to its intended use.

Page 19 ming Jumpers section of this guide. Be sure to keep the clips that hold the dash panel trim on for later use.

Avital Remote Start with Keyless Entry

If this does not svital, a tach wire should be used. Does the vehicle have an immobilizer? The company behind this system is Directed Electronics Since its inception, Directed Electronics has had one purpose, to provide consumers with the finest vehicle security and car stereo products and accessories available.

Then, twist the wires together and cover with tape.