Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout. ASTM C Standard Test Method for Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout. ASTM C/CM: Standard Test Method for Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout.

Author: Arashigami Zulkigrel
Country: Madagascar
Language: English (Spanish)
Genre: Automotive
Published (Last): 13 November 2011
Pages: 426
PDF File Size: 20.9 Mb
ePub File Size: 15.39 Mb
ISBN: 187-3-67709-274-5
Downloads: 56766
Price: Free* [*Free Regsitration Required]
Uploader: Faeshakar

ASTM C1090

This approach provided more simplicity in the execution of the test, rather than using a projector lamp, magnifying lens, and indicator charts as described in ASTM C see figure The laser approach has asm compared with the original setup, and similar results were obtained. In both test methods, there is always a certain c11090 of friction between the specimen’s sides and the inner surface of the metallic mold.

Historical Version s – view previous versions of standard. Testing of shrinkage for concrete – grout. Link to Active This link will always route to the current Active version of the standard.

After removal, the thickness of the glass plate was measured with a caliper at ast points of contact between the glass plate and the micrometer.

  DAVID ARORA MUSHROOMS DEMYSTIFIED PDF

[email protected]: Testing of shrinkage for concrete – grout.

Sieve size is identified by its standard designation in Specification E Though not recommended by the ASTM standards, and in order to provide the lowest friction possible, an acetate sheet was used in between the test specimen and the mold. It is the responsibility of the user of this asrm to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

The height change of a 3-inch mm -diameter by 6-inch mm -tall v1090 specimen was measured in accordance with ASTM C Combining values from the two systems may result in non-conformance with the standard.

The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. These test methods cover procedures for assessing the adhesion of coating films to metallic substrates by applying and removing pressure-s This thickness was then added to the four-reading initial measurement.

Two cylindrical specimens with the same dimensions as those used for the ASTM C test method were prepared in which the change in height was measured at four points on the top surface of the specimens using a micrometer in accordance with ASTM C at 1, 3, 7, 14, and 28 d see figure The degree of restraint varies with the mixture viscosity and degree of hardening.

  DALAIL KHAYRAT URDU PDF

The height change results in both test methods are expressed in terms of percentage increase or decrease of the original specimen height. The glass plate was c190 from the top of the test specimen after 24 h.

The alternative designation given in parentheses is for information only and does not represent a different standard sieve size. Newer Post Older Post Home.

Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Some values have only SI units because the inch-pound equivalents are not used in practice.

An exception is made when the options described in the section on test conditions are exercised. I married on 30 th June now having ast b For cementitious grouts, saturate the surface up to SSD.